Page 1 of 1

Automation copy/paste bug?

Posted: Wed Apr 07, 2021 11:07 pm
by MisplacedDevelopment
I copied automation between a MIDI file mod wheel track and an AUFX automation. It works apart from the second to last data point is in the wrong place. I don’t know how to post pictures here but please see the pictures at this link:

https://forum.audiob.us/discussion/4457 ... automation

The first picture is NS2 and that is what the automation looks like in the MIDI mod wheel track in MTS. The second picture is what it looks like after pasting the data into the AUFX automation window. Note the second to last data point is positioned incorrectly. If I manually shift it right then I can see it is at the correct y position but for some reason it was not correct in the x axis. I tried again with grid snapping off in case that was somehow causing it but that did not help.

Re: Automation copy/paste bug?

Posted: Thu Apr 08, 2021 1:59 pm
by Support
I think the second last dot is removed because the last two dots are at the exact same time. Will look into that


Giel Bremmers

Re: Automation copy/paste bug?

Posted: Thu Apr 08, 2021 2:45 pm
by MisplacedDevelopment
Thank you Giel.

Re: Automation copy/paste bug?

Posted: Fri Apr 16, 2021 3:09 pm
by Support
This is improved in version 4.1

Giel Bremmers

Re: Automation copy/paste bug?

Posted: Fri Apr 16, 2021 3:19 pm
by MisplacedDevelopment
Just noticed the update, I’ll give it a spin later. Thanks again!