Panning and volume level ratio

Discuss working with MultitrackStudio.
Post Reply
moxol
Posts: 170
Joined: Fri Apr 28, 2017 11:23 pm

Panning and volume level ratio

Post by moxol »

When you pan left or right, volume becomes lower, or that is how is perceived.

Is there some rule how much you should increase volume when you pan left or right, for example for every 1% panning from centre, increase volume level by X db?
moxol
Posts: 170
Joined: Fri Apr 28, 2017 11:23 pm

Re: Panning and volume level ratio

Post by moxol »

Just to add question: is panning in MTS just lowering volume of one side?
sinbad
Posts: 594
Joined: Mon Jan 30, 2006 9:01 pm

Re: Panning and volume level ratio

Post by sinbad »

It's simulated geometry. When the sound source is moved from the center, the distance between source and reciever increases, theoretically reducing the sound level.
Also the sound is directional and is being projected past the receiver so the perceived power level is reduced by a function of the angle betweeen the source and the receiver.
There are some other fancy theories behind it but that's how I understand it. :wink:

With pannng you can get some space in your mix.
moxol
Posts: 170
Joined: Fri Apr 28, 2017 11:23 pm

Re: Panning and volume level ratio

Post by moxol »

sinbad wrote:It's simulated geometry. When the sound source is moved from the center, the distance between source and reciever increases, theoretically reducing the sound level.
Also the sound is directional and is being projected past the receiver so the perceived power level is reduced by a function of the angle betweeen the source and the receiver.
There are some other fancy theories behind it but that's how I understand it. :wink:

With pannng you can get some space in your mix.
Thanks!
Didn't understand word of it, but thanks... :roll:

I thought that MTS just reduced volume level of one side, but after closer look, it does compensate volume and moves sound instead of just reducing volume left or right.
Support
Posts: 1717
Joined: Fri Aug 27, 2004 2:17 pm

Re: Panning and volume level ratio

Post by Support »

moxol wrote:Just to add question: is panning in MTS just lowering volume of one side?
If you're talking about stereo signals (rather than mono): it doesn't route the left channel to the right channel or vice versa. It just fiddles with the levels.

You can use a Stereo Effect if you want to pan the two channels separately.


Giel Bremmers
Post Reply